{"id":7177720955060,"title":"Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module","handle":"shutao-5pcs-pc817-2-channel-optocoupler-isolation-board-voltage-converter-3-6-30v-driver-photoelectric-isolated-module","description":"\u003ch3\u003eShutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module\u003c\/h3\u003e\n\u003cp id=\"b\"\u003eDriving port signal voltage:3.6-24V Output port voltage port:3.6-30V Jumper\ncap can achieve output port is high potential or pull down output Onboard\n4-channel 817 are independent: can achieve different voltage control at then\nsame time This module is used when it is necessary to isolate the control in\nactual work and voltage conversion. for the friend of the single-chip or PLC,\nit is only necessary to judge when the output port is low. The photoelectric\nisolation has strong anti-interference ability， and the combination control of\nmany different devices can be realized later, such as triode, MOSt u be, and\nsmall power relay module. Package include: 5 x PC817 2 channel optocoupler\nisolation board NOTE: The input port is shared with GND The output ports are\nindependent of each other It is optocoupler output.V and G will be connected\nafter input valid signa in input port\u003c\/p\u003e \n\n\u003ch3\u003eProduct Features\u003c\/h3\u003e\n \u003cul class=\"a\"\u003e\n \u003cli\u003eOnboard 2 channel 817 are independent: can achieve different voltage control at then same time\u003c\/li\u003e\n \u003cli\u003e2-way 817 optocoupler driving port signal voltage:3.3-24V; Output voltage range: 3.6-30V(The output current depends on the specific situation but not over 10MA. When the total power is fixed, the voltage and current are inversely proportional)\u003c\/li\u003e\n \u003cli\u003e2 way 817 optocoupler to achieve the control signal and the control signal isolation, you can directly use the microcontroller or other devices IO port to achieve voltage isolation control, you can achieve a small voltage control, the control side can be an external transistor MOS tube or different voltage levels Of the device interface\u003c\/li\u003e\n \u003cli\u003ePC817 module jumper cap can achieve output port is high potential or pull down output\u003c\/li\u003e\n \u003cli\u003eIf it is a pulse signal, please note that the limit of 817 is below 3KHZ. If the control signal is greater than 3KHZ, please do not use this module, it will not work properly.\u003c\/li\u003e\n \u003c\/ul\u003e\n\n","published_at":"2022-07-02T04:39:17+10:00","created_at":"2022-07-02T04:39:25+10:00","vendor":"Shutao","type":"IO Modules","tags":["industrial"],"price":11500,"price_min":11500,"price_max":11500,"available":true,"price_varies":false,"compare_at_price":null,"compare_at_price_min":0,"compare_at_price_max":0,"compare_at_price_varies":false,"variants":[{"id":41625876725940,"title":"Default Title","option1":"Default Title","option2":null,"option3":null,"sku":"B09P623S8K","requires_shipping":true,"taxable":true,"featured_image":null,"available":true,"name":"Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module","public_title":null,"options":["Default Title"],"price":11500,"weight":5,"compare_at_price":null,"inventory_management":null,"barcode":"0701715510203","requires_selling_plan":false,"selling_plan_allocations":[],"quantity_rule":{"min":1,"max":null,"increment":1}}],"images":["\/\/auspowers.com\/cdn\/shop\/products\/B09P623S8K.jpg?v=1656744742","\/\/auspowers.com\/cdn\/shop\/products\/71IyAkk-vnL.jpg?v=1656700765","\/\/auspowers.com\/cdn\/shop\/products\/71tnlIn7_HL.jpg?v=1656700765","\/\/auspowers.com\/cdn\/shop\/products\/61wC6VRShRL.jpg?v=1656700765","\/\/auspowers.com\/cdn\/shop\/products\/61UvpvPYdeL.jpg?v=1656700765","\/\/auspowers.com\/cdn\/shop\/products\/61n4nkgKDbL.jpg?v=1656700765","\/\/auspowers.com\/cdn\/shop\/products\/71M4lEqZQ0L.jpg?v=1656700765"],"featured_image":"\/\/auspowers.com\/cdn\/shop\/products\/B09P623S8K.jpg?v=1656744742","options":["Title"],"media":[{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26375994638516,"position":1,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/B09P623S8K.jpg?v=1656744742"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/B09P623S8K.jpg?v=1656744742","width":1601},{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26371254747316,"position":2,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/71IyAkk-vnL.jpg?v=1656700765"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/71IyAkk-vnL.jpg?v=1656700765","width":1601},{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26371254812852,"position":3,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/71tnlIn7_HL.jpg?v=1656700765"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/71tnlIn7_HL.jpg?v=1656700765","width":1601},{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26371254845620,"position":4,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/61wC6VRShRL.jpg?v=1656700765"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/61wC6VRShRL.jpg?v=1656700765","width":1601},{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26371254878388,"position":5,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/61UvpvPYdeL.jpg?v=1656700765"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/61UvpvPYdeL.jpg?v=1656700765","width":1601},{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26371254911156,"position":6,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/61n4nkgKDbL.jpg?v=1656700765"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/61n4nkgKDbL.jpg?v=1656700765","width":1601},{"alt":"[Australia - AusPower] - Shutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module ","id":26371254943924,"position":7,"preview_image":{"aspect_ratio":1.0,"height":1601,"width":1601,"src":"\/\/auspowers.com\/cdn\/shop\/products\/71M4lEqZQ0L.jpg?v=1656700765"},"aspect_ratio":1.0,"height":1601,"media_type":"image","src":"\/\/auspowers.com\/cdn\/shop\/products\/71M4lEqZQ0L.jpg?v=1656700765","width":1601}],"requires_selling_plan":false,"selling_plan_groups":[],"content":"\u003ch3\u003eShutao 5PCS PC817 2 Channel Optocoupler Isolation Board Voltage Converter 3.6-30V Driver Photoelectric Isolated Module\u003c\/h3\u003e\n\u003cp id=\"b\"\u003eDriving port signal voltage:3.6-24V Output port voltage port:3.6-30V Jumper\ncap can achieve output port is high potential or pull down output Onboard\n4-channel 817 are independent: can achieve different voltage control at then\nsame time This module is used when it is necessary to isolate the control in\nactual work and voltage conversion. for the friend of the single-chip or PLC,\nit is only necessary to judge when the output port is low. The photoelectric\nisolation has strong anti-interference ability， and the combination control of\nmany different devices can be realized later, such as triode, MOSt u be, and\nsmall power relay module. Package include: 5 x PC817 2 channel optocoupler\nisolation board NOTE: The input port is shared with GND The output ports are\nindependent of each other It is optocoupler output.V and G will be connected\nafter input valid signa in input port\u003c\/p\u003e \n\n\u003ch3\u003eProduct Features\u003c\/h3\u003e\n \u003cul class=\"a\"\u003e\n \u003cli\u003eOnboard 2 channel 817 are independent: can achieve different voltage control at then same time\u003c\/li\u003e\n \u003cli\u003e2-way 817 optocoupler driving port signal voltage:3.3-24V; Output voltage range: 3.6-30V(The output current depends on the specific situation but not over 10MA. When the total power is fixed, the voltage and current are inversely proportional)\u003c\/li\u003e\n \u003cli\u003e2 way 817 optocoupler to achieve the control signal and the control signal isolation, you can directly use the microcontroller or other devices IO port to achieve voltage isolation control, you can achieve a small voltage control, the control side can be an external transistor MOS tube or different voltage levels Of the device interface\u003c\/li\u003e\n \u003cli\u003ePC817 module jumper cap can achieve output port is high potential or pull down output\u003c\/li\u003e\n \u003cli\u003eIf it is a pulse signal, please note that the limit of 817 is below 3KHZ. If the control signal is greater than 3KHZ, please do not use this module, it will not work properly.\u003c\/li\u003e\n \u003c\/ul\u003e\n\n"}