DORHEA 5PCS TM1637 0.56" 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi Uno DIY Kits 5
DORHEA 5PCS TM1637 0.56" 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi Uno DIY Kits
Display device is 4-digit yang red digital tube Digital tube 8-level grayscale adjustable Working Voltage: 3.3V / 5v DC Working Current: 30 / 80MA LED Display: 0.36 inche Color: red highlights The driver IC is TM1637, only two signal lines can make MCU control four Digit 8-segment LED. Pinout: LED Display module to Arduino GND—ground (GND) VCC--power supply (5V) DIO--data input and output (D2) CLK--clock signal pin (D3) Package Includes: 5 X TM1637 4 bits digital LED display module 1 x Female to male jumper wire
Product Features
- The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube.
- Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V.
- 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance.
- Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin.
- The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination.