2pcs BTS7960 43A High Power Motor Driver Module/Smart Car Driver Module for Arduino Current Limit
2pcs BTS7960 43A High Power Motor Driver Module/Smart Car Driver Module for Arduino Current Limit
This driver uses chips BTS7960B composed of high-power drive full H-bridge driver module with thermal over-current protectionDouble BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driverSpecification:High-current 43ATwo heat flow passing through an error signal outputSupply voltage: 5.5V to 27V5V power indicator on boardJust need four lines from MCU to driver module (GND. 5V. PWM1. PWM2)Isolation chip 5 V power supply (can share with MCU 5V), can also use the on-board 5V supplycan solder heat sinkControl method: PWM or levelDuty cycle: 0-100%PIN Definition:RPWM: Right Turn PWMLPWM: Left Turn PWMR_EN: Right Turn Enable (High Active)L_EN: Left Turn Enable (High Active)R_IS: Right Turn Current Warning (May Leave Floating)L_IS: Left Turn Current Warning (May Leave Floating)VCC: (5V)GND:signal common low endPackage Included:2 BTS7960B H-bridge 43A High-Power Motor Driver Module
Product Features
- 5V isolate with MCU, and effectively protect MCU; 5V power indicator on board.
- Voltage indication of motor driver output end; can solder heat sink.
- Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V).
- Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output.
- Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V.