1″ Digital Turbine Flow Meter, Gas Oil Fuel Flowmeter, Pump Flow Meter Diesel Fuel Diesel Kerosene Line Pipe Counter for Chemicals Water etc(Blue)
1″ Digital Turbine Flow Meter, Gas Oil Fuel Flowmeter, Pump Flow Meter Diesel Fuel Diesel Kerosene Line Pipe Counter for Chemicals Water etc(Blue)
This digital turbine flow meter has modular design, high accuracy, compact size and stable performance. Easy to replace and maintain internal components. Intuitive clear reading, high reliability, measuring accuracy is ±1%.Suitable for use with output modules, sensors and remote transmitters. Can be widely used to measure diesel, kerosene, gasoline, etc. Specification: Operating voltage 2.3-3.3V Battery type 2 x AAA LRO3 batteries Thread size 1inch NPT Repetition ±0.5% Measure accuracy ±1% Maximum working pressure 20BAR Flow range 15-120L / Min Single count 0.00-9999.9 Total cumulative count 0-99999 Mistakes count 0.1000-9.9999 Working temperature -10°C ~ +60°C(14°F~140°F) Standby time 1 year Application Diesel, kerosene, gasoline Weight 371g Package list 1 x Blue Turbine Flow Meter; 1 x Manual
Product Features
- Brief introduction - The digital turbine flowmeter has a modular design, high precision, small size and stable performance. The modular design makes it suitable for use with output modules, sensors and remote transmitters. Easy to replace and maintain internal components.
- Feature - Compact structure, convenient installation, intuitive and clear readings, high reliability, measurement accuracy of 1%, high-definition display shows instantaneous and cumulative flow. Can be widely used to measure diesel, kerosene, gasoline, petroleum, medicine, transportation and commerce.
- When it appears - normal flow rate but the meter does not count, when the DISPLAY button is pressed, the meter is turned on. In this case, the possible cause is: 1. the impeller is stuck or damaged; 2. the sealant material is wrapped around the impeller; Solution: Remove the meter and ensure that the impeller rotates freely.
- When it occurs - the flow rate is reduced and the meter does not count when the DISPLAY button is pressed, the meter is turned on. In this case, the reasons may be caused by: 1. The meter is partially blocked by the dried liquid; 2. Below the minimum flow rate; Corresponding solution: remove the instrument to ensure that the impeller rotates freely; 2. Increase the flow rate.
- When the meter is not working properly, it may be due to a board failure or a button failure. The corresponding solution: replace the circuit board.